With more than 70 years in the refrigeration sector, our philosophy has always been to provide the best service and treatment to our customers.
INFORMATION
WATER CHILLERS
MACHINERY FOR INDUSTRIAL APPLICATIONS
Simplicity, reliability and efficiency
Whether you need to supply chilled water to a single process, or centrally to multiple processes, air-cooled chillers are the most common solution for installation simplicity, reliability and efficiency.
These chillers are the most requested solution in many industrial sectors, including: plastic, food and beverage, chemical, pharmaceutical, metallurgical, ceramic, electroplating, data center, etc.
AIR-COOLED WATER CHILLERS
THE RELIABLE AND EFFECTIVE REFRIGERATION SOLUTION
industrial refrigeration units air cooled They are units capable of guaranteeing high reliability in the most extreme service conditions with maximum functional efficiency, even in the worst environmental conditions.
They typically consist of:
-
One or two refrigerant circuits with scroll or screw compressors, plate or multitubular type evaporators to cool the water, and condensers for heat dissipation from the refrigeration circuit, using air as a medium - Refrigerant gas charge according to set point specifications
- Axial fans for forced air convection
- Hydraulic section complete with storage tank, recirculation pump and process pump
- Microprocessor panel for automatic function control
WATER CONDENSED CHILLERS
SIMPLICITY OF OPERATION
The operation of the chillers condensed by water is based, on the one hand, on certain principles of thermodynamics and, on the other, on advances in cutting-edge technology, which makes it possible to have equipment capable of reducing water temperature, increasing energy efficiency to the maximum and, therefore, , obtaining the best benefits, both in terms of production and sustainability.
For this, a closed cycle of the cooling fluid is needed, that is, without said fluid having to be replaced, it will carry out the required cooling over and over again. It is important to note that it cannot be just any fluid, but must have specific properties since, throughout the closed cycle, it will pass through different elements (compressor, condenser, expansion valve and evaporator) that will alter its state, its temperature etc
You want to know more?
